Pokud nežijete v hlubokých temných lesích, nebo hůře – nezajímá vás, jak Linux funguje, tak jste již museli slyšet o systemd, (relativně) novém init systému, jež postupně
7 Min Read
0
Two ways: One, under [Service] include a line „User=<username to run as>“. Two, use a systemd –user session. [Unit] Description=BitTorrent Sync service After=network.target
6 Min Read
0
For a software raid I’d do the following (but it might work for your controller too?): Install mdadm (should be on the cd): sudo apt-get
1 Min Read
0
systemd is used instead of init and hence the concept of runlevels is replaced by the term targets. So there is indeed a mapping between
1 Min Read
0
You can activate the wlan by these commands instead of repluging: sudo modprobe -r 8192eu sudo modprobe 8192eu You need change 8192eu to your own
1 Min Read
0